Gecko sd converter

For this part you'll actually have to open the case and get your hands dirty - and it requires special screwdriver bits. Qoob Lite. When you get it apart you solder the mod chip directly to the board. You don't need to add hook up wire as the back of the board has only solder mask. If you use fresh flux with fresh solder and a nice, bigger-is-better bevel tip or chisel tip not a too-small or conical tip , it's very easy to get right and clean up if you get wrong.

As far as I can tell, there's no way to softmod your GameCube without having access to already-modded Homebrew system. Optionall copy other. Either Swiss will load automatically, or you'll have choose to load the hacked save file from the in-game load menu. If it seems like things just froze and aren't loading, don't give up hope until you hit the 2 minute mark.

This is true for many homebrew operations. If you're lucky you can exit back to the boot launcher. If it seems to be frozen, you can either wait up to a solid 2 minutes to see if it loads, just just go ahead and restart right away. If you consider yourself a technotard and you're more handy with a screw driver than a command prompt and you're not afraid of the physical world , you may very find that it's way easier and far less complicated to just open up the darn thing to get the job done.

What you're looking for is something with the really dark dye dark dark purple. In the past, Verbatim and Ritek especially G04 and G05 were the most reliable brands for the best dvd backup burning. However, these days they're expensive, you may not use them for much else, and you won't even know if the ones you buy work until you've already bought them. Can you upload the memorycard pinout again,because the link of the picture is down.

Thanks in advance. Bobplayer , Jan 19, No, it's not. Prog , Jan 19, You must log in or sign up to reply here. Show Ignored Content. You can even add a LED in parallel to the data line, so you can see, when the cube is reading data. Dont forget to connect EXI pin 1 and 12, if your card not already has it, otherwise the cube won't recognize the device.

It is possible to swap SD pin 3 and 6 or EXI pin 2 and 10 or connect them all together common ground. The data line the LED is attached to, is 3.